What are the various accessories recommended for Aluminium doors?

Various accessories for Aluminium doors are following:

A spring-loaded bar that is mounted horizontally on the side of a door, opens outward. When pushed upon the bar, the bolt is released.
This device is compulsory where the fire exits.
Many of these doors are one-way, and cannot be opened from the outside. To use this device on a two-way door, another type of handle must be mounted on the opposite side.

• DOOR FASTENERS -
• Latch :
  A door fastening device has no locking function.
• Lock :
  A device that prevents access by those without a key or combination.
• Rim lock:
  A lock which is built up to the outer surface of a door.
• Bolt:
  A metal pipe, usually internal to the door that extends to the jamb(vertical side of a doorway) fastens a door.
  They are typically manipulated with a lock on the outside and a lock on the inside. Bolts are generally used for security purposes.
• Latchbolt:
  A bolt whose surface acts as a base to push the bolt inside while the door is being closed.
  By the use of a latch bolt, a door can be closed without operating the handle.
• Deadbolt:
  Deadbolts usually extend deeper into the frame and are not automatically retractable the way while the latch bolts are.
  They are typically manipulated with a lock on the outside and either a lock or a latch on the inside.
  Deadbolts are generally used for security purposes on external doors.
• Push Plates:
  Push plates are properly located to receive the normal hand push.
  These are centered 45" from the bottom of the frame.
• Crossbar:
  A fastener consisting simply of a plank or beam mounted to one side of a door by a set of hooks.
  The board can be slid past the frame to block the door. Alternatively, the bar can be a separate piece that is placed into open cleats or hooks, extending across the frame on both sides.
  This device is essentially opposite of the crash bar that it effectively makes the door one-way while in us.
Hinge:
A joint that holds two parts together so that one can swing relative to the other.
A component that attaches one edge of a door to the frame while allowing the other edge to swing from it.
One door usually has about three hinges but it can vary.
These are made of stainless steel, aluminum, brass and iron.
Hinges come in a large variety of sizes and weights.
There are various hinges such as
Butt hinges, slip hinges, joint hinges, flag hinges, T-hinges, spring hinges, bi-fold screen hinges, latch hinges, concealed hinges, strap hinges and even hinges have anti-microbial coating to control bacteria, mold and mildew
• DOOR VIEWER:
  Optical device fitted into a hole in front of a door enables observation without opening the door.
  Viewer has a curved lens in it to magnify an image on the other side of the door. Viewers have various degrees of vision.
• DOOR CLOSER:
  These are devices for closing doors or gates automatically after opening.
  They may be overhead or floor mounted and either exposed or concealed.
  There are two general styles of door closers:
• Manual and automatic:
  A manual door closer will close a door after it has been opened by hand.
  An automatic door closer opens the door itself, typically under the control of a push button, motion detector or other device and then closes it as well by detecting whether it is safe to close the door.
• DOOR BELLS:
  A push button at outer door that gives a ringing or buzzing signal when pushed.
• DOOR FRAMES:
  A frame for a door consisting of two vertical jambs and a head. A sill may be included for an outer door.
• Custom Aluminium door frame
• Aluminium sliding door frame
• Jamb:
  It is a vertical post that forms the sides of a door frame where the hinges are mounted with which the bolt interacts.
• Sill:
  A horizontal beam below the door that supports the frame.
• DOOR STOPPERS:
  It is a thin slat built inside the frame to prevent a door from swinging through when closed. Hinges might break without their use.
• ARCHITRAVE :
  It is a decorative molding that outlines a door frame.